Aurene Alabaster Disc Flush Mount

Aurene Alabaster Disc Flush Mount · Natural Alabaster & Brass · Integrated LED Panel · 4 Sizes

Aurene Alabaster Disc Flush Mount — Brass Ring Ceiling Light

A round alabaster panel sits flush against the ceiling inside a brass ring, lit from behind by a factory-installed LED panel rather than individual bulbs. Small brass studs on the face echo the ring above, and the whole disc glows evenly rather than casting light from a single point. Available in four sizes, the smallest suits a hallway or closet, while the largest works as the main light in a bedroom or living room. There's no bulb to buy or swap — the LED panel is built in and runs on a fixed warm white glow.

Key Features

• Round natural alabaster panel, backlit for even, glare-free light — each piece has unique veining
• Brass ring frames the edge, with matching brass studs on the face
• Factory-installed integrated LED panel (continuous matrix) — non-replaceable, no bulb to buy
• Flush mount — sits close to the ceiling with no visible drop or stem
• Available in 4 sizes: Ø 7.8", 11.8", 15.7", or 19.7"

Size

XS

Ø 7.8" (20 cm)

H 2.6" (6.5 cm)

Small

Ø 11.8" (30 cm)

H 2.6" (6.5 cm)

Medium

Ø 15.7" (40 cm)

H 2.6" (6.5 cm)

Large

Ø 19.7" (50 cm)

H 2.6" (6.5 cm)

Finish: Gold & White (brass ring, alabaster panel) — one finish option.

Specifications

MaterialBrass ring, natural alabaster panelFinishGold & WhiteLight SourceFactory-installed integrated LED panel (continuous matrix) — non-replaceableColor TemperatureWarm Light, ~3000KDimmingNot dimmableMountingCeiling — flush mount, hardwiredVoltageAC 110-240VEnvironmentIndoor, IP20SizesØ 7.8" / 11.8" / 15.7" / 19.7" · all H 2.6"CertificationsNA / SA / EU / AU

Size & Dimensions

Where It Works

The smaller sizes suit a hallway, closet, or powder room; the larger sizes work as the primary ceiling light in a bedroom, living room, or dining room where an even, glare-free glow is preferred over a chandelier or multi-bulb fixture.

Downloads

FAQ

Can I replace the bulb if it burns out?

No — the LED panel is factory-installed and non-replaceable. If it fails, the whole fixture would need to be serviced or replaced under warranty.

Can I dim this light?

No — the integrated LED panel has a fixed warm white output and is not compatible with a dimmer switch.

Do I need an electrician to install this?

Yes. This is a hardwired flush mount fixture that connects to a ceiling junction box and should be installed by a licensed electrician.

Why does my alabaster look different from the photo?

Each panel is cut from natural alabaster, so veining and translucency vary slightly piece to piece — this is expected, not a defect.

Natural alabaster is quarried, not manufactured — expect unique veining and subtle translucency variation between pieces.